BYDPQ - TRICHEM 715

Product Identification

Product ID:TRICHEM 715
MSDS Date:07/27/1990
FSC:8010
NIIN:00N061012
MSDS Number: BYDPQ

Responsible Party
PACIFIC ANCHOR CHEMICAL CORP
5701 S EASTERN AVE SUITE 530
LOS ANGELES, CA 90040
US

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 401-333-4100

Cage: 0EMW2

Contractor
PACIFIC ANCHOR CHEM CORP,(TRIMONT CHEMICALS)
CUMBERLAND, RI 02864

Telephone: 401-333-4100

Cage: 0EMW2

Ingredients

EPON 820; (BISPHENOL A/EPICHLOROHYDRIN BASED EPOXY RESIN)

CAS: 25068-38-6

RTECS: KC2100000

Fraction By Weight: 86-90%

OSHA PEL N/K

ACGIH TLV: N/K


PROPANE, 1-BUTOXY-2,3-EPOXY-; (TECHNICAL GRADE BUTYL

CAS: 2426-08-6

RTECS: TX4200000

Fraction By Weight: 10-14%

OSHA PEL 50 PPM

ACGIH TLV: 25 PPM


EQUIP (APRON, FOOTWEAR, ETC.) SHOULD BE

RTECS: 9999999ZZ


HYGIENE AND SAFE WORKING PRACTICE.

RTECS: 9999999ZZ

Hazards

LD50 LC50 Mixture:SEE INGREDIENT 2
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:HIGH CONCENTRATIONS OF VAPOR
CAUSE IRRITATION OF EYES AND RESPIRATORY TRACT. NOTE:BUTYL GLYCIDYL
ETHER IS MUTAGENIC IN VITRO. CHRONIC:PROLONGED OR REPEATED EXPOSURE
MAY CAUSE ASTHMA AND SKIN SEN SITIZATION OR OTHER ALLERGIC
RESPONSE.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NOT KNOWN.

First Aid

First Aid:EYES:FLUSH W/WATER FOR @ LST 15 MIN, HOLDING EYELIDS OPEN.
GET MED ATTN. SKIN:WASH THORO W/WATER WHILE REMOVING CONTAM CLTHG &
SHOES. WASH CLTHG BEFORE REUSE & DISCARD CONTAM LEATHER ARTICLES.
GET MED ATTN IF EFTS SUCH AS SWELLING/REDDENING OCCUR.
INHAL:REMOVE TO FRESH AIR IF EFTS OCCUR & ADMIN OXYG IF NEC. GET
MED ATTN IF EFTS PERSIST. INGEST:GET MED ATTN. INDUCE VOMIT IMMED
BY DEPRESSING(SUPDAT)

Fire Fighting

Flash Point:137F,58C
Extinguishing Media:FOAM, DRY CHEMICAL, CARBON DIOXIDE (CO*2)
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT . COOL FIRE-EXPOSED CONTAINERS WITH WATER.
Unusual Fire/Explosion Hazard:TOXIC FUMES WILL BE EVOLVED WHEN THIS
MATERIAL IS INVOLVED IN A FIRE.

Accidental Release

Spill Release Procedures:AVOID CONT W/MATL. ABSORB SPILL
W/CLAY/DIATOMACEOUS EARTH & SHOVEL INTO DISP CNTNR, REMOVE ANY
SURROUNDING CONTAM SOIL. WASH PAVED AREAS W/WATER, BEING CERTAIN
THAT DILUTED MATL IS NOT FLUSHED INTO ST ORM DRAINS/WATER SUPPLIES.
WEAR APPROP PROT EQUIP.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:PREVENT ALL SKIN AND EYE CONTACT.
AVOID BREATHING VAPORS. RE-SEAL PARTLY USED CONTAINERS.
Other Precautions:ENSURE THAT ALL CONTAINERS ARE PROPERLY LABELLED TO
PREVENT ACCIDENTAL INGESTION.

Exposure Controls

Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATORY PROTECTION
REQUIRED IN THE ABSENCE OF PROPER ENVIRONMENTAL CONTROL. FOR
EMERGENCIES, A SELF-CONTAINED BREATHING APPARATUS OR FULL-FACE
RESPIRATOR IS RECOMMENDED.
Ventilation:BRTHG OF VAPS MUST BE AVOIDED. VENT MUST BE SUFFICIENT TO
CTL VAPS. MATL SHOULD BE CONFINED AS FAR AS POSS W/IN (SUPDAT)
Protective Gloves:IMPERVIOUS GLOVES, NEOPRENE OR RUBBER.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS(SUPDAT)
Other Protective Equipment:EMERG EYE WASH & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA . CLEAN, BODY-COVERING CLTHG. FURTHER SFTY
(ING 3)
Work Hygienic Practices:WASH W/SOAP & WATER BEFORE EATING, DRINKING,
SMKING/USING TOILET FACILITIES. OBSERVE CNDTNS OF GOOD INDUST (ING
4)
Supplemental Safety and Health
FIRST AID PROC:BACK OF TONGUE W/FINGER/DRINKING 1/MORE GLASSES OF SALT
WATER. VENT:SEALED/COVERED EQUIP IN WHICH CASE NORMAL VENT SHOULD
BE ADEQ. SPECIAL (LOC) VENT WILL BE NEEDED IN AREAS WHERE VAPS ARE
EXPECTED TO BE VENTED. EYES:AND FULL LENGTH FACE SHIELD .

Chemical Properties

Boiling Pt:B.P. Text:327F,164C
Vapor Density:4.5
Spec Gravity:1.12-1.14 @ 77F
Solubility in Water:SLIGHT
Appearance and Odor:STRAW COLORED LIQUID.

Stability

Stability Indicator/Materials to Avoid:YES
AVOID BRINGING INTO CONTACT WITH ACIDS, CAUSTIC MATERIALS AND AMINES.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:CO (CARBON MONOXIDE), CO*2 (CARBON
DIOXIDE).

Disposal

Waste Disposal Methods:DISPOSE OF AS HAZARDOUS WASTE IN ACCORDANCE WITH
FEDERAL, STATE AND LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.